This standard is issued under the fixed designation D ; the number immediately This test method was adopted as a joint ASTM–IP standard in operator prepares and inserts the beakers (with test oil, covers, and stirrers) into the bath as per ASTM D method. The test rod assembly (includes the steel. Model is a 6 test positions agitated liquid bath conforming to ASTM D, D, D, NACE TM and other similar tests. A timer alerts the.
|Published (Last):||28 June 2018|
|PDF File Size:||17.58 Mb|
|ePub File Size:||3.95 Mb|
|Price:||Free* [*Free Regsitration Required]|
Steel test specimen for D, each. Individual stirrers have the ability to be lifted out of the test beaker by simply loosening the knurled holding nut and lifting from the beaker.
The stainless steel bath has drain for easy replacement of the bath medium. Horizontal disc test specimen for D, each. Model A is an asgm dry bath with 4 positions.
ASTM D Rusting Characteristics of Petroleum Products
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Mounted on the control panel is a power switch for turning the stirrers on and off without disturbing the power to the bath.
A protective cover is provided over the motor. Work Item s – proposed revisions of this standard. Model is identical to Model but with only 4 test positions.
Clear plastic stirrers’ shield for 6 position baths. C0 Standards Related Products 1. Historical Version s – view previous versions of standard. It is used for specification of new oils and monitoring of in-service oils. For specific warning statements, see 6.
FTM Paddle and Shaft. Provision is made in astmm procedure for testing heavier-than-water fluids. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C0 Standards Related Products. Link to Active This link will r665 route to the current Active version of the standard. For synthetic fluids, such as phosphate ester types, the plastic holder and beaker cover should be made of chemically resistant material suitable for the type of fluid tested. The design chuck is as specified by the test method.
Rust-Preventing Characteristics of Mineral Oil – ASTM D665, D3603, D7548 | NACE TM-01-72 | IP 135
Specifications subject to change without notice. This test method is also used for testing hydraulic and circulating oils, including heavier-than-water fluids. This feature, unlike conventional aluminum block baths allows precise temperature adjustment.
Clear plastic stirrers’ shield for 4 position baths. The advantage of the these aluminum baths over a liquid bath is the safety with the elimination of fumes and fire hazards if using oil as the bath medium. This test method asym used as a basis for Test Method D Polishing device with chuck Volts. Manual Liquid Bath for Rust Testing, 6 positions.
A timer alerts the operator to method critical steps requering attention. A digital tachometer is provided displaying the rotational speed of the stirrers. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Note 1—For synthetic fluids, such as phosphate ester types, the plastic holder and beaker cover should be made of a chemically resistant material, such as polytetrafluoroethylene PTFE. Link to Active This link will always route to the current Active astn of the standard. Home Products Contacts Search.
Active view current version of standard. Models A and B are identical to Models A and B, respectively, but with 6 test positions. This standard does not purport to address all of the safety concerns, if any, associated with its use.
Each position is d66 temperature controlled and independent of other positions. Silicone carbide paper grit 50 sheets.
For specific warning statements, see 7.
Vertical test specimen for D includes specimen, washer, capeach.